OpenWRT on Netgear WNDR3700, IPv6 edition!
Wednesday, June 8. 2011
Happy IPv6 day everyone!
Here's how I went about it:
Here's how I went about it:
- Triple-30 reset your router: with router on, press reset and hold; after 30 secs, pull the plug but keep reset; after 30 secs put back the plug, keep reset; after 30 secs release reset and power cycle.
- Confirm triple-30 reset: router management page should ask for factory password. If not, retry triple-30 reset.
- With router off, hold reset and turn on router. Keep reset until power led blinks green (After ~35 secs.)
- tftp -i 192.168.1.1 PUT openwrt-ar71xx-wndr3700-squashfs-factory.img
- Do nothing! Wait until the firmware is completely initialized. Check with ping -t 192.168.1.1
- Access http://192.168.1.1/ (Luci) and change root password under Administration. There's no default password.
- Still in Luci, configure your wan interface. Apply & save. Reboot.
- SSH to root@192.168.1.1
- sysupgrade http://downloads.openwrt.org/snapshots/trunk/ar71xx/openwrt-ar71xx-generic-wndr3700-squashfs-sysupgrade.bin
- opkg install kmod-ipv6 radvd ip kmod-ip6tables ip6tables 6to4 kmod-sit
- vim /etc/config/network
- Add to end:
config interface 6rd
option proto 6to4
option adv_subnet 1 - vim /etc/config/radvd
- Change interface option 'ignore' to 0
- /etc/init.d/network restart
- In Luci, add the '6rd' interface to the wan zone
- In Luci, add the following firewall rule: name 6to4, source wan, protocol 41, target accept. Save.
- In Luci, make sure radvd starts at startup. Apply & Save. Reboot.
Trackbacks
Trackback specific URI for this entry
No Trackbacks
Comments
Display comments as
(Linear | Threaded)
Hi,
sorry for the off, but idk if you receive any notification, if I comment on older posts, so
There is a D program mention in this post: http://lunesu.com/index.php?/archives/106-Converting-my-mobile-phone-into-an-IR-remote-control.html
Could I see the source code? I am very interested about it. Maybe the wav files too, if it's possible.
Thx, Sziky
sorry for the off, but idk if you receive any notification, if I comment on older posts, so
There is a D program mention in this post: http://lunesu.com/index.php?/archives/106-Converting-my-mobile-phone-into-an-IR-remote-control.html
Could I see the source code? I am very interested about it. Maybe the wav files too, if it's possible.
Thx, Sziky
FYI, this is written for WNDR3700 hardware v1. If you have v2, you need to flash a different firmware. It isn't available in10.03, but is in 10.03.1-rc5, locate at http://downloads.openwrt.org/backfire/10.03.1-rc5/ar71xx/ . Note that there is a version marked "-NA". I chose to use this since I'm in the U.S.
You'll also have to make sure you use 10.03.1-rc5 when you do the sysupgrade.
You'll also have to make sure you use 10.03.1-rc5 when you do the sysupgrade.
Random Picture
Quicksearch
My Favorites
Categories
Timezones
- Shanghai: 15:40
- Bucharest: 09:40
- Eindhoven: 08:40